Icom IC-910H IF Output Modification
I looked about on the net for how to modify my Icom IC-910H to bring the main band IF out on a connector at the rear of the radio but couldn't find anything so I dug out my service manual and went at it myself.
When I say this is a modification this isn't really true, the only thing needed done was to attach some thin coax to a point on the PCB and bring it to said connector on the rear panel of the radio.
When I say this is a modification this isn't really true, the only thing needed done was to attach some thin coax to a point on the PCB and bring it to said connector on the rear panel of the radio.
This modification was need for my Flex-1500 interface project where I can monitor the IF output of the IC-910H on my Flex-1500 SDR radio using the supplied PowerSDR software.
For the modifcation you need to take the bottom cover of the radio off, this is simple enough to do. Follow the
For the modifcation you need to take the bottom cover of the radio off, this is simple enough to do. Follow the
Full IF Mod and Dissassembly Instructions
instructions_for_ic-910h_main_band_if.pdf | |
File Size: | 1196 kb |
File Type: |